Prepare before opening the zip
Kiwi Wool’s Premium New Zealand Alpaca Adjustable Pillow contains alpaca fleece pearls in a cotton cover. Its removable filling lets you change the fullness. This routine is for that model; it is not an instruction to open a sewn wool pillow or cut into any pillow casing.
Use a clean, dry surface and have a clean container or bag ready for any filling you remove. Put on the pillowcase you normally use when you test the pillow. A case that squeezes the pillow can change its feel, so check that fit before removing more filling.
A small-change routine
- Try the starting feel. Lie in your usual position on your own mattress. Notice whether the pillow feels too full, too low or uneven.
- Remove a little, not a large section. If it feels too full, unzip it on the clean surface. Take out a small amount of pearls from across the filling rather than hollowing out one corner.
- Redistribute gently. Spread the remaining fill evenly by hand. Keep pearls clear of the zip, then close it fully.
- Put the pillowcase back on. Test the same position again. Avoid changing the mattress topper or adding another pillow during the comparison.
- Keep the removed fill. Store it clean and dry so you can reverse the change. Try the new setting over a few nights before making another small adjustment.
Use the feel to choose your next step
| What you notice | Try next |
|---|---|
| Too full or high | Check the case is not tight, then remove a little filling evenly. |
| Too low after adjustment | Add some of the clean, dry filling back and redistribute it. |
| One side feels lumpier | Even out the existing pearls before changing the total amount. |
| Good on your side, too full on your back | Test a smaller adjustment in both positions. Seek a comfortable compromise rather than a fixed height rule. |
| Still uncomfortable after careful changes | Pause and discuss the model and your setup with Kiwi Wool. |
Keep a short trial note
You do not need to weigh every handful. A note makes it easier to remember whether the last change helped. Use the same words each time so you can compare like with like.
My starting point: usual sleep position, mattress and pillowcase.
My change: removed a little / added some back / redistributed only.
What I noticed: fuller, lower, more even, comfortable or still unsuitable.
Next step: keep this setting, reverse it or ask for help.
If the pillow feels good after redistribution alone, you may not need to remove anything. If you keep alternating between two unsatisfactory settings, describe that to the team rather than continuing to take filling out.
Care for the pillow you have adjusted
The zip allows adjustment; it is not permission to machine wash the shell or filling. The current alpaca pillow instructions say dry-clean only, with gentle spot cleaning using minimal water for small marks. Keep removed filling away from moisture and household mess.
For cleaning questions, use the pillow care guide. If you need more filling, ask Kiwi Wool whether it can supply a suitable match.
A few useful answers
How much filling should I remove?
There is no universal amount. Start small, redistribute evenly and test. Keep removed filling so the adjustment is reversible.
Should I choose Medium or High?
Medium is about 16 cm high and High about 18 cm. Our natural pillow guide explains which suits your sleep position, and you can ask Kiwi Wool if you are unsure before ordering. Adjustment fine-tunes the starting model.
Can adjustment guarantee better sleep?
No. It gives you control over the amount of filling and the feel of this pillow. It is not a treatment or a guarantee of a particular sleep outcome.
